problem with the machine

[nidbe]

hello, I have a problem with the machine (AMADA fo 3015) it discharges almost 4 times in 8 hours (etj'obtenu of bad cuts in all the great thickness
Note: I change the bottle yesterday GAS Lasallian 83 ... and it is possible that there's a default at the gas ...

thank you all

 

[JayMaechtlen]

I can't quite understand what you mean about the discharge. I assume you mean that the laser faults out or shuts down due to some problem. Since it started happening (as I understand it) after you changed gas, you should try another bottle of gas.
Maybe consider which supplier you are using, too.

Jay Maechtlen

http://www.laserpubs.com/techcomm

 

[Foostrap]

What alarm do you get when the resonator shuts down?
Check the PSU voltage at base discharge (laser sequence 30), and compare to the values on the Fanuc datasheet.
Do a leak test to make sure that is OK as well.