Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Problems using Adams Car 1

Status
Not open for further replies.

Miankovelo

Student
Mar 26, 2023
19
Hello,
I am working with Adams Car. I have been able to open my imported model in the Adams View interface of Adams car but when I go back to the Standard interface of Adams Car, the model disappears. Can someone please help me? Thank you in advance
 
Replies continue below

Recommended for you

Hmmm. This usually only happens if you have switched from "Template Builder" but are trying to switch back to "Standard Interface" mode. And vice versa.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor