Problems w/DT & Excel Sheets allowed?

[Lady2]

I keep getting the error message "no valid design sheet found" except when I open the design sheet in a separate window, then it recognizes it and works fine. Does anyone know why? I am using an excel file with several sheets (each sheet a separate Design Table), is this a problem? I know the DT is setup right because it works when opened in a separate window. I'm using v2003. Thanks for any advice.

 

[tchouk]

Make sure that you have "Family" written for name box for the cell A2 on all your sheets.
In additon check that you have a emty row under your configuration name.

 

[SBaugh]

You have to have Sheet 1 active, when you close the DT in the file. Otherwise you will get that error.

Regards,

Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376