Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Problems with curvatures

Thread starter ferro1001
Start date Aug 11, 2004

Status: Not open for further replies.

Aug 11, 2004

ferro1001

Automotive

Hello,

I am doing a model in CATIA in order to import it to ABAQUS. This model has some parts with curvature ratio of about 20 meters and when I try to join a line, for example,in the squetch with a curve with this curvature it doesn´t join well, when I zoom the join point I see there is a gap. Anybody knows how to work this out?

Thanks