Project curve in an assembly draft, NX7.5. 1

[Cmott]

Drafting an assembly in 7.5, the Project curve no longer works. I can’t pick on any of the splines or curved edges. It works in a part but not in an assembly. It worked fine in NX5 part and assembly. I do have the sketch active in the view I am working on. Am I missing something? I need to use this to create hatched areas.

 

[cowski]

Make sure your selection filter is set to 'entire assembly' and not something like 'work part only'.

www.nxjournaling.com

 

[Cmott]

Thanks, I tryed that and I am still not able to pick anything.

 

[jerry1423]

This might be worth trying:
In the View Style
In the General tab, towards the bottom, change the extracted views from none to associative

 

[Cmott]

jerry1423, That worked!! Thank You!