Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

propagate callout to component

Status
Not open for further replies.
multicaduser

multicaduser

Industrial
Jan 29, 2013
261
Can the callout in an assembly with a bom be propagated to the component? The attribute property of the component in the assembly looks like this.

Capture1_ev1jf7.png


And the attribute property in the component itself looks like this.

Capture2_niqx9b.png


It's most likely something obvious but I'm missing it.

Thanks in advance.

NX 1980 Windows 10
 
Status
Not open for further replies.

Similar threads

Ram K
  • Locked
  • Question
Thread callout in Drawing
Replies
1
Views
635
Toost
Toost
MANox
  • Question
Number of holes in Hole and thread callout
Replies
0
Views
1K
MANox
MANox
Werner K
  • Locked
  • Question
Pull expression values into a component when adding to an assembly
Replies
5
Views
522
Werner K
Werner K
A
  • Locked
  • Question
NX10. Assembly Navigator. Column with freeze status of component
Replies
3
Views
1K
cowski
cowski
DDerek
  • Locked
  • Question
How to make "Balloon" Result in only the number for the callout
Replies
3
Views
345
SDETERS
SDETERS

Part and Inventory Search

Sponsor

Back
Top Bottom