Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Publishing Cabling Assemblies into ProductView

Thread starter Haym
Start date Nov 6, 2002

Status: Not open for further replies.

Nov 6, 2002

Haym

Mechanical

Does anyone have a solution for this.....

Having published a ProE assembly (which contains many Pro/Cabling features) into ProductView-
ProductView, visually, fails to load any Pro/Cabling part into the browser. However, the part is displayed into the ProductView Model tree !!!
Is there any Configs to check/amend so that ProductView publishes both ProE components/assemblies and all Pro/Cabling components.

Note, I'm currently using ProE 2001 (2002140), Intralink 3.1 2001361) and ProductView (2002046). ...Haym LOL