Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pump selection in watercad

Thread starter WaterGIS
Start date Jun 27, 2015

Status: Not open for further replies.

Jun 27, 2015

WaterGIS

Geotechnical

greetings
i have a water network, where i know the demand at each point and the layout of the network...
the network should be feed using pumps from reservoir,,, im trying to figure out how to know what is the total flow and total head which i should chose the pump based on.
im using watercad