question about skeleton

[SrGilberto]

I created a skeleton for a cabinet design. It works very nicely for the individual parts and their overall lengths/width/height. However, now I want to control mounting holes that are patterned for the side panels.

I can adjust the pattern increments as a part length changes to spread the mounting holes apart if the cabinet gets taller or to make them closer together if the cabinet is shortened, but suppose I want the number of side mounting holes to change from 6 to 5 when the height of the cabinet is shortened to a certain length or shorter?

Thanks already,
SrG

 

[mloew]

SrGilberto,

I had a similar problem which was resolved quite well in the thread # of instances in pattern table (thread554-86497). Hope this helps!


Best regards,

Matthew Ian Loew


Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.