Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Question concerning bending stress commando for beam4

Status
Not open for further replies.

Lorens

Structural
Feb 23, 2006
14
SE
Hi!

I have done a model for which I have used beam4 element, I have with the element table plotted the torque and then used the SBYT, SBYB commando (SBZT, SBZB) to plot the bending stress for that axis.

The problem is that the bending stress and torque plot of the same axis, don’t correspond were you will see bending stress in areas were you don’t see any torque around that given axis.

I have no idea what to do, I am very grateful for any given assistance.

Kindly Paul-Martin
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top