Hi everyone!
i'm having a look to AGMA 2003-B97 in order to create an easy worksheet for sizing bevel gears.
I think i had a good result in wear strength, but the results in bending stress are too out of the parameters.
in my opinion σ_Flim is too low, but the charts told me this.
I attach my sheet, i wish to know if i did something wrong (the bending section is T1:W12)
i'm having a look to AGMA 2003-B97 in order to create an easy worksheet for sizing bevel gears.
I think i had a good result in wear strength, but the results in bending stress are too out of the parameters.
in my opinion σ_Flim is too low, but the charts told me this.
I attach my sheet, i wish to know if i did something wrong (the bending section is T1:W12)