Question on Projected views??????!!?!?!?!?!?!?!?

[CADWHORE]

I need to pull a projected view off of a main view at an angle of 27.13. I have sectioned view with a hole at this angle and need to create a view to give a hole callout. Any ideas??? I have been trying to just eyeball it and get as close as I can, but it is not working to well.

Thanks,

 

[4mranch1]

Can you go into the view and insert a line, thru the hole center point, that can be identified as the Hinge Line?

Gary Ashby
Designer

 

[CADWHORE]

Gary,

I just tried that, and the resulting view still needs to be rotated another 90 degrees to make the hole in the correct orientation. Any other ideas??

 

[4mranch1]

Put a line perpendicular to the centerline and use it as the Hinge Line.

Gary Ashby
Designer

 

[CADWHORE]

Worked great, thanks Gary!!!!!!