Quick opening closuer for pig trap? 1

[J.I.h]

dears engineeres I just got the document from our vendor, I asked to check the calculation for example hub verification, and they gave me a simple calculation without any detailed calculation, only a result. Please, if anyone can help me with this calculation, send me some documents that I can refer to.

 

[GBTorpenhow]

What design code was the closure specified as conforming to? I'm used to seeing either ASME B31.8 or ASME BPVC Section VIII for these, but other design codes may govern. Whatever design code was specified will have the calculations you are looking for.

 

[0707]

Your piping pig trap shall fit your piping system design.

 

[J.I.h]

Dear GBTorpenhow the design based on ASME VIII Div 1