Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Rack & pinion design in inventor

Status
Not open for further replies.

PriyankPadaria

Mechanical
Jun 9, 2015
17
I need to generate Rack & Pinion in inventor.
Would you like guide me for that???!!!
Inventor shows spur, bevel & worm gears on power transmission tab in design tab.
 
Replies continue below

Recommended for you

Pinions are just spur gears so you can use the design accelerator to generate them. The rack doesn't have any fancy involute curves, so you can model that yourself without much trouble.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor