Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Radial menu selection gestures

Status
Not open for further replies.

Ron Frack

Automotive
Nov 12, 2019
1
US
Hello, I'm currently using NX11 and recently had my OS updated to windows 10. I'm having an issue with my radial menus where after the menu pops up I have to hover directly over a command/function to get it to start, where as before the update I could move my mouse in the general direction of the command on the menu I wanted and it would start.
Radial_Menu_issue._vqgjln.jpg
 
Replies continue below

Recommended for you

Sounds like a graphics driver issue.
Try this (I always do this), you know the positions of the Icon's by head?
You don't have to wait until the radial pops up. Just moving your cursor in the corresponding direction will already activate the icon. (see attached movie)



Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX12 / TC11
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top