Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

radius dimensioning 1

Status
Not open for further replies.
Mike Brosseau

Mike Brosseau

Mechanical
Jul 24, 2017
5
In NX9, how do you create a radius dimension where the dimension line originates at the centerpoint of the radius? In previous versions, we had Radius to Center dimension. Now, I cannot see how to do this.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Create a radial dimension (not in inferred mode) and you can RMB to place a to centre dimension.
Uploaded video should explain better than I can in words.


Anthony Galante
Senior Support Engineer


NX3 to NX11 with almost every MR (24versions)
 
Upvote 0 Downvote
Anthony, thanks a million!! This has been driving me crazy for a while. Made my day.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

ewh
  • Locked
  • Question
Folded Radius Dimension
Replies
2
Views
137
ewh
ewh
Suskam
  • Locked
  • Question
Multiple Leaders for a Radius Dimension
Replies
0
Views
111
Suskam
Suskam
nxexplorer
  • Locked
  • Question
NX JOURNAL in NX CAM to get the tool diameter and radius of each operation
Replies
1
Views
253
nxexplorer
nxexplorer
loworange88
  • Locked
  • Question
Dimensioning - Extension line weight when printing
Replies
5
Views
160
loworange88
loworange88
JModelsalot
  • Locked
  • Question
Radius to a reference 2
Replies
13
Views
154
Toost
Toost

Part and Inventory Search

Sponsor

Back
Top Bottom