Radius Flip Issue

[Shrey_Aac]

I have been facing the following issue in NX
The two radii are driven by expressions and these expressions are changed by a journal.
Before running journal that changes the radii values

After running journal that changes the radii values

Please suggest a solution to prevent this flipping of the arcs.

PS.I am a newbie on this forum so please excuse any posting errors

Thanks in advance!

 

[NutAce]

Hi

Defining radii in sketches is bad practice.
It works much better if you add the radius as a blend on your extruded model.
There you can use the same expression to configure them with your journal.

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX12 / TC11