dvcrogers
Electrical
- May 15, 2003
- 33
I have been away from Autocad for a few years now so I am a little rusty. I am using Land Desktop 3 and I have inserted an aerial photo that is a .sid file. I have it on it's own layer which is unlocked, thawed, and plot-enabled. I cannot get it to plot though. I have tried IMAGEFRAME-it's set to on. We are plotting to an HP Designjet 4000, it is raster capable. Is there any kind of toggle that will prevent this image from plotting eventhough it is showing up in the drawing?
Thanks
Dave Rogers
dvcrogers@yahoo.com
Thanks
Dave Rogers
dvcrogers@yahoo.com