jbwalker
Mechanical
- Oct 14, 2015
- 1
I'm at a new start-up company with newly installed RCS Heat xChanger software.
I do the inputs and run the job, but I keep getting the same error when I try to view
the Bill of Material (BOM) -
It reads "error executing program:\RCSWIN\Programs\RCS_edit b-file.int"
I can't tell If this is a software problem, or if I missed something when doing the design inputs and running the job.
Any Help is appreciated, and thanks in advance.
jb
I do the inputs and run the job, but I keep getting the same error when I try to view
the Bill of Material (BOM) -
It reads "error executing program:\RCSWIN\Programs\RCS_edit b-file.int"
I can't tell If this is a software problem, or if I missed something when doing the design inputs and running the job.
Any Help is appreciated, and thanks in advance.
jb