Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Red dot on icons 1

Status
Not open for further replies.

mmauldin

Bioengineer
Jul 16, 2004
484
US
What does the red dot on the icons indicate?
red_dot_ohexs3.jpg
 
Replies continue below

Recommended for you

Those are features/dialogs that have changed when a new version of NX is installed. Somewhere there's a setting to turn that off but I can't seem to find it again. I'm sure someone else will know.


Mike
 
Thanks. I vaguely suspected that it might be that, not knowing was driving me crazy.
 
It's turned off in the Discovery Centre, when it's in the What's New mode.

2022-09-16_10-18-02_utaoth.png


Anthony Galante
Senior Support Engineer


NX9 to NX2206 (12 versions)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top