AndersSande
Industrial
Hi all,
On large format multiple sheets drawings of large and complicated component I have seen som reference tables on sheet 1.
The tables listed where on the drawing the actual section views and datum references where layed out. The tables listed on what sheet and where on the this sheet. I can't remember how these tables where formatted.
Could someone give me some samples or somting on such table?
It was even noted on every section view where the section line was, as some of the section lines where on other sheets than sheet 1.
I remember theese view references as:
Section A-A
Sh2 H4
And the datum tables as:
Datum Position
A Sh 5 B2
Is there any standard for this, or is it different from every company?
The actual drawings I worked with was from SNECMA and General Elecric.
Any samples or standards?
Regards,
Anders
On large format multiple sheets drawings of large and complicated component I have seen som reference tables on sheet 1.
The tables listed where on the drawing the actual section views and datum references where layed out. The tables listed on what sheet and where on the this sheet. I can't remember how these tables where formatted.
Could someone give me some samples or somting on such table?
It was even noted on every section view where the section line was, as some of the section lines where on other sheets than sheet 1.
I remember theese view references as:
Section A-A
Sh2 H4
And the datum tables as:
Datum Position
A Sh 5 B2
Is there any standard for this, or is it different from every company?
The actual drawings I worked with was from SNECMA and General Elecric.
Any samples or standards?
Regards,
Anders
