Regarding Lifting Lug Calculation in PV Elite 2018 1

[Jibin C Benoy]

Hello Friends,
Recently I started to design pressure vessels in PV Elite 2018 version.
I'm getting an error while giving Lifting Lugs to a vessel "Warning: CG of Vessel is too near or Outside the Lift Points!" as shown in attached image.
Can anybody help me how to sort it out, asap ?

 

[SnTMan]

Not from that.

Regards,

Mike

The problem with sloppy work is that the supply FAR EXCEEDS the demand

 

[JStephen]

Sounds like you have the lifting lugs too low, where the whole assembly might conceivably flip over while lifting. Raise the lifting lugs, or possibly go from 2 to 3 or 4 depending on the geometry at hand.

 

[Jibin C Benoy]

Thankyou so much JStephen for your clarification