Region of inflation layers around an aerofoil

[power106]

I'm currently modeling an aerofoil in Ansys.

I have a question about inflation layers in Ansys.

I've been attempting to place a region of inflation layers around the aerofoil, and have not been managed to do so.

After generating the mesh I am given the following message,

"The default defeaturing tolerance was larger than one computed based on size controls. The mesher has modified the global defeaturing tolerance accordingly."


The current mesh looks like this,

The following mesh is what I hope to achieve,

Any help, tips would be greatly appreciated.

Best regards,

power106

 

[power106]

After generating the mesh I am given the following message,

http://files.engineering.com/getfil...4ef5-8052-3f3b93a26769&file=Error_Message.JPG

The current mesh looks like this,

http://files.engineering.com/getfil...e55-9302-0236148aefe9&file=Current_Result.JPG

The following mesh is what I hope to achieve,

http://files.engineering.com/getfil...51-91fd-b0d1a46635b5&file=Inflation_Layer.JPG