reinforcement pad for nozzle inner side of wall or shell 9

[Zubir MMHE]

Dear all,

I am looking for design that can be my reference for nozzle reinforcement pad design inner side of wall for pressure vessels or tanks. Based on ASME VIII, UG-37 not specifically mentioned reinforcement pad (repad) must locate outside but the schematic showing it in common, repad is place outside. Is there anyone of us has had experience weld the repad inner side of wall?

thank you

Zubir

 

[Zubir MMHE]

Hi r6155,

Sure i read your email Sir. Can i have your email address? hope we can communicate with detail with regard to the repad. I hope you don't mind

 

[r6155]

Zubir MMHE
It's not ethical. We must share knowledge among all of us.

Regards

 

[Zubir MMHE]

Hi r6155,

Sorry about that. Could you share at least sketch from the previous project, interested how it looks like to comply with ASME guideline

 

[r6155]

It is simple, it is the same as the external reinforcing pad.
Sorry but this is my last comment on this topic, it was enough.
I understand that you must do a training course.

Regards

 

[Zubir MMHE]

Thank you r6155 Sir,

your input most valuable. Yes I may need some training course.

Also still waiting for other expert on the subject of repad.