Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Relief valve set pressure acceptance criterion (ASME vs API)

Status
Not open for further replies.
mthakur

mthakur

Mechanical
May 8, 2003
44
ASME section VIII specifies acceptance criterion for cold differential test pressure of relief valve which is +/- 2.5%. Can this be applied to an API valve? or API has their own set of specifications on this?
 
Status
Not open for further replies.

Similar threads

EMANUELE GUERRINI
  • Locked
  • Question
ASME I Boiler with 15 PSI Pressure - Can I Use an ASME IV Safety Valve?
Replies
2
Views
429
The Obturator
The Obturator
M
  • Question
ASME 16.5 2020 vs 2013 wrong pipe OD
Replies
0
Views
137
minodi
M
Q
  • Question
ASME B 31.3 Impact test Exception API 5L PSL2 GR B
Replies
2
Views
2K
QAQC33
Q
teokal
  • Question
Saddle calculations for ASME VIII Div.2 Pressure Vessel - paragraph 4.15
Replies
0
Views
1K
teokal
teokal
OntarioMech
  • Locked
  • Question
ASME B31.1 App. II - Low pressure relief valve, open discharge piping
Replies
2
Views
212
KevinNZ
KevinNZ

Part and Inventory Search

Sponsor

Back
Top Bottom