caro06
Marine/Ocean
- May 6, 2009
- 2
Hi,
I am new using flow works, and I have a problem putting boundary conditions for an internal analysis ("Face<1> is not laying on the boundary between solid and fluid region"). Check geometry gives me a 0 m^3 fluid volume, but I can't find where my solid is not closed.
In the help topic, they give the following tip : "Add mates where applicable. This may remove small gaps/defects which may be hard to find". Problem is, I am not english and I don't understand what "mate" means apparts from "buddy"... Is it some kind of envelope that would fill in the gaps ?
If anybody knows some way to solve my problem, all the ideas are welcome !
Thanks
I am new using flow works, and I have a problem putting boundary conditions for an internal analysis ("Face<1> is not laying on the boundary between solid and fluid region"). Check geometry gives me a 0 m^3 fluid volume, but I can't find where my solid is not closed.
In the help topic, they give the following tip : "Add mates where applicable. This may remove small gaps/defects which may be hard to find". Problem is, I am not english and I don't understand what "mate" means apparts from "buddy"... Is it some kind of envelope that would fill in the gaps ?
If anybody knows some way to solve my problem, all the ideas are welcome !
Thanks