JJ2013
Structural
- Feb 19, 2011
- 6
Actually, posted this same question on the wrong forum at first....
A friend is working on an assembly drawing at work (she got that assembly drawing from someone else) during which solid works tells her the design needs to be REBUILT (I guess this is because of conflicts in references or mates). She does her best addressing the issue and has used the REBUILD command repeatedly but the software keeps asking her to rebuild. It's like a never ending loop. She'd redone the design several times but runs into this brick wall all the time.
Would appreciate some advice very much!
JJ
A friend is working on an assembly drawing at work (she got that assembly drawing from someone else) during which solid works tells her the design needs to be REBUILT (I guess this is because of conflicts in references or mates). She does her best addressing the issue and has used the REBUILD command repeatedly but the software keeps asking her to rebuild. It's like a never ending loop. She'd redone the design several times but runs into this brick wall all the time.
Would appreciate some advice very much!
JJ