Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Repeat Last Command

Status
Not open for further replies.

catiaUSR

Aerospace
Apr 9, 2014
28
US
Hey!

Does anyone know how I can setup a Creo Map Key (hot key) to repeat the last command? For example, if I hit the Assemble button then I close the Assemble window, I would like to be able to hit 'a' or 'b' etc on the keyboard and for that to open the Assemble window again.

Thanks
 
Replies continue below

Recommended for you

Mapkeys replay existing Creo commands. Unless PTC creates a "do last command" function there is nothing for a mapkey to replay.
 
Don't hold your breath.

----------------------------------------

The Help for this program was created in Windows Help format, which depends on a feature that isn't included in this version of Windows.
 
Last command functionality does not play well with a WIMP interface, it does a lot better when you are using a command driven interface.
Think Windows GUI vs Command prompt window.

"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top