Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Repetitive constraints

Status
Not open for further replies.
illustrator15

illustrator15

Mechanical
Apr 4, 2011
16
DK
Hi All,

I am working on an assembly which is migrated from IDEAS to NX 7.5 and has lost all the ocnstraints in it. There are many nuts, bolts and washers in it which require repetitive constraints commands. Is there any way to copy sequence of constraints and then apply it to required parts.

Thanks in advance!
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

Mirza98
  • Locked
  • Question
NX Assembly - Component arrangement specific without any constraints?
Replies
3
Views
56
cowski
cowski
El_Paben
  • Locked
  • Question
Sketch Constraints NX2206 1
Replies
16
Views
80
El_Paben
El_Paben
jerry1423
  • Locked
  • Question
Assembly Constraints - Ball End 1
Replies
5
Views
36
jerry1423
jerry1423
Ian Hood
  • Locked
  • Question
Mechanical route - Applying constraints to Linear Path
Replies
0
Views
11
Ian Hood
Ian Hood
Bruce McGlothin
  • Locked
  • Question
NX 1973 Sketcher and profile/arc length constraints
Replies
8
Views
37
jerry1423
jerry1423

Part and Inventory Search

Sponsor

Back
Top