Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Report in Model Compare

Thread starter LayKanae
Start date Dec 2, 2015

Status: Not open for further replies.

Dec 2, 2015

LayKanae

Industrial

Hi Everyone!
I'm using the NX 10 command "Model Compare" to review the changes that might have one of our parts ...

I wonder if there is way of knowing the approximate value of the differences between one face and another, because when I generate the report it indicates the faces with numbers and the approximate deviation, but i dont know how to identify the faces in my model