Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Require to model ID fan

Status
Not open for further replies.
sunnyfriday

sunnyfriday

Chemical
Oct 14, 2004
6
Hi, I need to model the gas flow across ID fan, i have datas of temp and pressure at the inlet and outlet of fan and also power datas for fan. typical values for pressure is -2kpa at suction and +3kpa at discharge of ID fan.
 
Status
Not open for further replies.

Similar threads

Fuzzbox 100
  • Locked
  • Question
P&ID Symbol - Metering Pump
Replies
6
Views
467
shvet
shvet
Sreejith sp
  • Locked
  • Question
required a vacuum pump, how to select a vaccum pump which suits my application and how to get a supp
Replies
0
Views
100
Sreejith sp
Sreejith sp
SAEEDGH
  • Locked
  • Question
convert sae30 graph to sae 120
Replies
2
Views
88
Artisi
A
h4m
  • Locked
  • Question
Back to Back vs Face to Face Seal Arrangement
Replies
2
Views
149
Pandeyji
Pandeyji
AspenMech
  • Question
Rated flow rates not in 80% to 110% of BEP flowrates
Replies
19
Views
674
LittleInch
LittleInch

Part and Inventory Search

Sponsor

Back
Top Bottom