Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Reset position after using "capture & return"

Status
Not open for further replies.
venomex

venomex

Automotive
Jan 12, 2015
92
Hello all,

How can I obtain the original co ordinates of parts after using "Capture & return" option in Motion workbench/kinematics?
The .sim file assembly has the parts in captured position.
How can I reset it back to the original position to start a fresh simulation?

Shetty,
Using NX 10.0.1.4
 
Status
Not open for further replies.

Similar threads

Asieros
  • Locked
  • Question
Siemens NX Drafting - Reset the "Border to Arrow Distance"
Replies
0
Views
568
Asieros
Asieros
MANox
  • Locked
  • Question
Change tabs bar posiotion to "centered"
Replies
2
Views
295
MANox
MANox
Anton Liubimov
  • Locked
  • Question
NxOpen, How to programmatically open a dialog box "Extrude"
Replies
2
Views
538
Anton Liubimov
Anton Liubimov
johnny777886
  • Locked
  • Question
NX2206 Hole Table Numbers Reset
Replies
0
Views
227
johnny777886
johnny777886
esikoglu
  • Locked
  • Question
thePart.CAMSetup.CAMGroupCollection.FindObject("MCS_MILL"); cannot find the object
Replies
0
Views
151
esikoglu
esikoglu

Part and Inventory Search

Sponsor

Back
Top Bottom