Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

RESISTIVITY of Si

Status
Not open for further replies.
emily126

emily126

Structural
Mar 17, 2005
11
Hi~

Once I found that resistivity of p-type Si is 7.8e-8 T??m, is it equal to 7.8?cm?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
T=Terra=10e12 then you're right...but not every p-doped Si has this specific resistivity...it depends on the implanmtation treatment

 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Faraz1997
  • Locked
  • Question
How to reduce number of iterations in tabular data of transient thermal analysis
Replies
3
Views
454
NRP99
NRP99
Zain_117
  • Locked
  • Question
Prestressing of strands in ANSYS
Replies
0
Views
71
Zain_117
Zain_117
M9angesh
  • Locked
  • Question
Hi All, I am currently doing FEA Si
Replies
2
Views
58
FEA way
FEA way
netsonicyxf
  • Locked
  • Question
APDL Optimization: There are too many levels of *Do
Replies
0
Views
91
netsonicyxf
netsonicyxf
HilaryE
  • Locked
  • Question
Best Ansys software for recreation of granulate flow
Replies
0
Views
54
HilaryE
HilaryE

Part and Inventory Search

Sponsor

Back
Top Bottom