Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Results Manipulation - Combination with no units?

Thread starter JinT4191
Start date Jul 5, 2013

Status: Not open for further replies.

Jul 5, 2013

JinT4191

Aerospace

Hi everybody,

I tried combining loadcases of my results with the NX tool results manipulation. The problem is when I try to combine the Glue Traction loadcases it gives me no units. How could I edit the settings so there are the right Units with MPa? For any other loadcases it would give me the right units. The only problem I have is with the Glue Traction. Hope anybody could help me on this!

Thank you for your thoughts!