Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Rib Sectioning

Thread starter GTI18T
Start date Aug 28, 2003

Status: Not open for further replies.

Aug 28, 2003

GTI18T

Industrial

I model and detail cylindrical cast parts with interior ribs with UG v18. the proper way to detail these ribs is with half scale hatching on the solid parts and full scale hatching on the ribs. Does anyone know of a more efficiant method to achive this than to use INSERT-->CROSSHATCH? Second, there seems to be an issue with manual crosshatching updating properly when there is a threaded throuogh hole involved in the section, is this a known issue and is there any way to fix it?
thanks.