Franklin M.
Aerospace
- Jan 20, 2018
- 59
Hi all,
I've tried to use the HEAD feature under tools several times but with limited success. It works if I use a postbuilder post, but not with a cls. The doc's say the coordinates will reflect the offset in the HEAD tool but it doesn't work. We use third party posts thus a cls is a must. I'm using V12, I have tried it in V4 and V6, same non-result. Am I doing something wrong or am I missing something.
I have a series of parts to program that use a small right angle head in mid program, now would be a great time to get the HEAD feature to work. All help appreciated.
Regards, Frank
Franklin
UG 10,13 & 18
NX 1,2,4,6,11 & 12
NCL502 (yep I love Sequential Mill)
I've tried to use the HEAD feature under tools several times but with limited success. It works if I use a postbuilder post, but not with a cls. The doc's say the coordinates will reflect the offset in the HEAD tool but it doesn't work. We use third party posts thus a cls is a must. I'm using V12, I have tried it in V4 and V6, same non-result. Am I doing something wrong or am I missing something.
I have a series of parts to program that use a small right angle head in mid program, now would be a great time to get the HEAD feature to work. All help appreciated.
Regards, Frank
Franklin
UG 10,13 & 18
NX 1,2,4,6,11 & 12
NCL502 (yep I love Sequential Mill)