Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ripples on .25 .38 and .50 hrs steel after a corner

Thread starter Venom2012
Start date Oct 7, 2022

Status: Not open for further replies.

Oct 7, 2022

Venom2012

Industrial

Hello I am running a f1 4020 6000w co2 amada laser I am having issues where after my sharp corners I get ripples on my .25 .38 and .50 hrs steel I have tried the recovery but I am having trouble all my holes are coming out great and after about an inch it smooths back out but it just can't seem to recover anyone have any suggestions out there?