Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Risafloor creating a simple wall

Status
Not open for further replies.

Sam1993

Structural
Jan 12, 2022
30
hello,
I was trying to draw a one simple wood wall on grids then I doubled click on the wall I got an error says that : wall panels must be rectangular, coplanar and no longer than .5 feet (Error code 2129)

Any solution to this problem?
 
Replies continue below

Recommended for you

RISA3D help file said:
Error 2129 : Wall panel need to be rectangular, coplanar, vertical, and at least 1.5 inches long.

A wall panel needs to be rectangular, coplanar, and vertical, as well as be at least 6" tall. The warning log should indicate which wall panel and which condition was violated. The wall panel joints must be adjusted to make it vertical, rectangular, and coplanar.

Is your wall actually rectangular, planar, vertical, >1.5" long, and >6" tall? Doublecheck the corner coordinates.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor