Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Rotating in the Z axis
- Thread starter warion7
- Start date
Dude,
have you tried to just rotate in top view?
Use the power selector and click the rotate icon AND ...
Then snap to the Center of your object...
That should do the trick ...
Otherwise? I believe you have to draw construction lines to rotate at the center point or base point you're after.
Hope that helps ....
Later!
Rich@LG (Architect)
have you tried to just rotate in top view?
Use the power selector and click the rotate icon AND ...
Then snap to the Center of your object...
That should do the trick ...
Otherwise? I believe you have to draw construction lines to rotate at the center point or base point you're after.
Hope that helps ....
Later!
Rich@LG (Architect)
- Status
Similar threads
- Locked
- Question
- Locked
- Question