Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Rule

Status
Not open for further replies.

Santa123

Mechanical
Oct 2, 2006
80
0
0
PL
Hej,

How can I input data to Rule

if class =="myclass" and bolt =="M6"
{
D=11mm
L =7mm
d = InputBox("give me hole dimeter") --- ???
}
else if ....


Best Regards
Santa
 
Replies continue below

Recommended for you

Status
Not open for further replies.
Back
Top