Hi all, I want to run abc.cmf file in Hypermesh from command prompt. Which command should I use for this? I have found out for running .tcl files from command prompt as - /hw/bin/ /hw.exe -clientconfig hwpost.dat -b -tcl example.tcl Similary can it be applicable for running .cmf commands? Thank you all in advance!

Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

running .cmf file from command prompt in hypermesh

Thread starter technodam
Start date Apr 18, 2016

Status: Not open for further replies.

Apr 18, 2016

technodam

Mechanical

Hi all,

I want to run abc.cmf file in Hypermesh from command prompt. Which command should I use for this? I have found out for running .tcl files from command prompt as -

<altair_home>/hw/bin/<platform>/hw.exe -clientconfig hwpost.dat -b -tcl example.tcl

Similary can it be applicable for running .cmf commands?

Thank you all in advance!