SACS weight load error message, please help

[tomorrow1960]

I leaned this software by reading and go through old training material. Did two simple project went well.

But I get error on the weight and acceleration whe I applied weight under weight menu then use acceleration under environment. I don’t know why since I used same method before.

saclst Listing Error 17 *** SLV MODULE TERMINATED DUE TO ERRORS DETECTED IN THE PRE MODULE ***
saclst Listing Error 19 *** POST PROCESSOR TERMINATED DUE TO PREVIOUS ERRORS
saclst Listing Error 97 *** ERROR - LABEL INCW NOT RECOGNIZED AS PROPER
saclst Listing Error 99 *** ERROR - LABEL ACCE NOT RECOGNIZED AS PROPER

I changed weight on joint to make it simple and still get error message. Can anyone help me to find out why or where I did wrong?

Thanks first.

 

[c2l]

hi,
i reviewed your file, in addition of what you mentioned, you didn't define sections, and not yet assigned,
Regards

 

[tomorrow1960]

Thanks c2l.

 

[c2l]

welcome