Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Save as new revision, skip numbers 1
- Thread starter Walterke
- Start date
-
1
- #2
I'm not sure about you intend. Could you explain about your exact requirement?
It is not possible to do like that...But you can delete the revisions once you created it if you want to see only 01 and o5.
Regards,
Manik
Shoot for the moon.
Even if you miss, you’ll land among the stars.
It is not possible to do like that...But you can delete the revisions once you created it if you want to see only 01 and o5.
Regards,
Manik
Shoot for the moon.
Even if you miss, you’ll land among the stars.
- Thread starter
- #3
Setting the revsion level of a file copy should be an option within TeamCenter. If not, open an IR and request that as an enahncement.
In many cases, you are bringing existing parts into a system that may already be at rev 5. Why should you have to revise the part 5 times and then delete files to get it there. FYI: Windchill allows us to set the revision when we save or copy a part just for this reason.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
In many cases, you are bringing existing parts into a system that may already be at rev 5. Why should you have to revise the part 5 times and then delete files to get it there. FYI: Windchill allows us to set the revision when we save or copy a part just for this reason.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
- Status
