scaling

[shimoni]

hello
im using solid 2001 and want to know if there is a possibility to scale my part at the part view and not only at the drawing. i want to print a section view of my assemly at 1;1 scale but didnt found the way to do so without using the drawing sheet.
regards
shimoni

 

[MadMango]

I don't think you can print 1:1 from the model, you have to use a drawing. "The attempt and not the deed confounds us."

 

[Seymour]

Have you tried File\Page Setup and setting the scale to 100%? Then section your assembly, orient it to the desired view, and print it. It will print in full scale.

 

[SBaugh]

When you make the part or assembly you should make it 1:1. Unless you scaled it on purpose, for like a mold.

Regards, Scott Baugh, CSWP
3DVision Technologies
credence69@REMOVEhotmail.com

http://www.3dvisiontech.com

http://www.3dmca.com

*When in doubt always check the help*

 

[SnowCrash]

The drawing sheet has a scale. Right click in an open part of the sheet/properties/scale. Set the scale for the overall drawing here.
Views can be set individually when created or afterwards. Right click in a view window, select and set custom scale.
The printing scale can be set.
Menu Click file/print/page setup Set scale 100% or adjust, or select print to fit page.
So that is three ways to get what you seem to want.

Crashj "page two . . ." Johnson