Oct 24, 2009 #1 moog2 Mechanical Jan 16, 2007 441 can anyone help me with any tips as to how to work with .stl scan data, as it doesn't seem to be very selectable?
can anyone help me with any tips as to how to work with .stl scan data, as it doesn't seem to be very selectable?
Oct 24, 2009 #2 hudson888 Mechanical Jun 19, 2007 2,275 What are you kidding me I just told you that you can section it! You build geometry though the curves. If you have the studio module there is even an assistant, but it still comes down to working with curves. Best Regards Hudson www.jamb.com.au Nil Desperandum illegitimi non carborundum Upvote 0 Downvote
What are you kidding me I just told you that you can section it! You build geometry though the curves. If you have the studio module there is even an assistant, but it still comes down to working with curves. Best Regards Hudson www.jamb.com.au Nil Desperandum illegitimi non carborundum
Oct 24, 2009 Thread starter #3 moog2 Mechanical Jan 16, 2007 441 mmmm i know, don't know what happened there, i posted this, then later, had alook but it wasn't there so i did another one ?? Upvote 0 Downvote
mmmm i know, don't know what happened there, i posted this, then later, had alook but it wasn't there so i did another one ??
