cowski
Mechanical
- Apr 23, 2000
- 8,174
When I plot a certain drawing, the section line's linescale looks huge (not the width, but the length of the dashes and spaces) but it looks ok on the monitor. It behaves the same way on multiple computers, existing drawings with section views (or new drawings with section views) plot the way they should. The original release was ok (we keep images of all revisions on file), the problem showed up in rev 1. I have been unable either to find a setting to control the linescale of section lines or to recreate the problem on a new drawing.
To make matters even more confusing, if I update the drawing then 5 of the 6 section lines change to solid linetype.
Any ideas?
Still chugging along on NX2 at this point.
To make matters even more confusing, if I update the drawing then 5 of the 6 section lines change to solid linetype.
Any ideas?
Still chugging along on NX2 at this point.
