Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Section out of a drill bit

Status
Not open for further replies.

cathalfinch

Mechanical
Joined
Apr 21, 2011
Messages
2
Location
IE
I’m trying to do up a drawing where there’s a missing segment on the thread of a drill bit and am having difficulty with it. The problem is that the section is at an angle. Can someone think of a way that this can be done ?? I’ve included a drawing of what I’m trying to do below. Thanks

 
Are you asking how to make the cut feature or how to make the section view?
 
You can sketch out the section line in the model and make a plane to create the A-A section with. For your plane use Through Curve & Normal to Sketch plane.

Section B-B needs to be created as an offset x-sec by selecting Offset instead of Planar and picking a Plane to sketch on and sketching the two lines of the B-B section line.

Michael
 
Hi, It's the cut feature itself I'm looking to make.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top