Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Section view corruption MD4 to MD6

Thread starter Nickdavy
Start date Feb 20, 2003

Status: Not open for further replies.

Feb 20, 2003

Nickdavy

Mechanical

I have upgraded from MD4 to MD6 (with Inventor6)

Section arrows and lines on views I created in MD4 do not display properly in MD6, the line through the part tends not to display and the arrows point away from the line not towards the line. The views however remain correct.

How can I get the drawings to display correctly in MD6?