Section View Help

[Bester2]

This is probably an easy question but can you move a section view so that it is no longer in line with where you cut the section? I have a very long tube that will have multiple section views taken along it's radius. I would like to place these views under the section line not in line with it.

Thanks in advance

Brian

 

[AnnaWood]

Right Mouse Button on the view and click Break Alignment

Regards,

Anna Wood
SW 2007 SP4.0, WinXP
Dell Precision 380, Pentium D940, 4 Gigs RAM, FX3450

http://designsmarter.typepad.com/solidmuse

http://www.phxswug.com

 

[Bester2]

Thanks Anna. I should have figured that one out on my own.

 

[Bouke]

Even faster way would be holding CTRL while placing the view.

Bouke Brouwers
M-Des
The Netherlands.