Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Seismic requirements for Bridge superstructure 1

Status
Not open for further replies.

KOKONIS36

Structural
Oct 28, 2001
28
US

What are the seismic requirements for Concrete and steel superstructures ? Any references ?
 
Replies continue below

Recommended for you

please refer to latest codal requirement of your area.
seimic force will assessed on the basis of the mass of the structue.
 
Kokonis36,

Two comments on your question:
1) Fundamentally, bridge design follows the weak column/strong beam concept (basically opposite of buildings.) Because of this, the superstructure (bridge deck) is a capacity protected element and must be able to behave elastically under plastic hinging of the column. The AASHTO I-A seismic code describes the design specifics for both steel and concrete superstructures.

2) Depending on your specific location, several codes in high seismic areas have included a vertical component to the seismic design forces (typically 2/3 the horizontal spectra, but this is very general.) Again, the superstructure needs to remain elastic under this event.

Your question was fairly broad, but I hope this helps, or starts further discussion.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top